Suzuki outboard motors 1988 2003 repair manual., Page 306Get this manual
8-38 LOWER UNIT the gearcase to 14.22 psi (1.0 kglcm)With the gearcase pressurized, spray soapy water onto the seals and check for escaping air bubbles, O-rings and oil seals for cracks, tears and wear Propeller for nicks, bent blades or other damage and wear Cooling circuit for clogging or other obstructions Gearcase for rusting, pitting and distortionASSEMBLY
+ See accompany in illustrations
Clutch control rod
2Clutch shaft side arm
I,lnstall new propeller shaft housing bearing with an appropriate installer2Install new propeller shaft housing oil seals and new housing 0ringCoat the seal lips and O-ring with an appropriate waterproof marine grease3Remove and discard the driveshaft bearing housing oil sealInstall new seal with an appropriate installerCoat seal lips with waterproof marine grease4, Lubricate all parts with Suzuki Outboard Motor Gear Oil5Install the driveshaft spring thrust washer in the sequence shown3Bush
4.Clutch shaft