Suzuki outboard motors 1988 2003 repair manual., Page 276Get this manual
8-8 LOWER UNIT Drive shaft 2Shim 3Pinion shim
3lnstall the propeller shaft shims and propeller shaft in the gearcase housing4Position the pinion gear and shim(s) in the housing under the driveshaft bore, insert the driveshaft and engage the pinion gearlnstall the E-clip on the end of the driveshaft to retain the in ion aear5lnstall the driveshaft seal pipe water tube6Remove the water pump case bearing and oil seal7, Install new bearing with an installer (09914-79510)8lnstall new oil seal and coat its lips with waterproof marine grease9Before installing the water pump case to the gearcase, apply waterproof marine grease to the oil seal10Also apply waterproof marine grease to the O-ring11, lnstall the water pumpBe sure to position the water pump impeller in the direction shown in the illustrationNote that the impeller vanes curve back relative to the direction of rotationDon't forget to install the impeller pin4.Pinion