Suzuki outboard motors 1988 2003 repair manual., Page 241Get this manual
POWERHEAD 7-29 36, Install the reed valve assembly and tighten attaching bolts securely, 37Install the inlet case and tighten the bolts to specification in several stages using the proper tightening sequence38lnstall all previously removed components to the powerheadSee accompanying illustrations
I,Remove all components still attached to the powerhead until the unit is down to the bare cylinder block assembly2, Remove the exhaust cover bolts3Using pry bar, remove the exhaust cover and plate4, Remove the silencer cover5, Position the power unit with the case and silencer facing downwards on level surface so that it will not fall over,
Place thick rubber sheet under the silencer to prevent scratching the surface05007G2F
Fig12 Cylinder head tightening sequence-