Suzuki outboard motors 1988 2003 repair manual., Page 202Get this manual
6-10 OIL INJECTION 6The clearance between the oil pump lever and the lever stop should be 0.04 in(Imm)7If the clearance is not as specified, readjust the control rod to achieve the proper clearance8Hold the connectors and control in place and tighten the locknuts securely9The control rod clevis ends should be positioned at 90�to each other after tightening the lock nuts10Check for proper oil pump discharge rateDT55 and DT65
See Figure 17
The throttle linkage must be adjusted prior to performing this procedureFor more information on throttle linkage adjustment, refer to the "Fuel System" section 1Remove the engine cover2Loosen the locknuts on the control rod3Move the throttle to the fully closed position4The clearance between the oil pump lever and the lever stop should be 0.04 in(1mm)5If the clearance is not as specified, adjust the control rod to achieve the proper clearanceFig17 Oil pump control rod adjustment-DT55 and DT65