Suzuki outboard motors 1988 2003 repair manual., Page 201Get this manual
OIL INJECTION 6-9 Except DT55, DT65, DT115 and DT140
See Figures 14,15 and 16
The throttle linkage must be adjusted prior to performing this
procedureFor more information on throttle linkage adjustment, refer to the "Fuel System" section 1Remove the control rod from the anchor pins on the oil pump lever and the throttle body lever2Loosen the locknuts on the control rod3Adjust the control rod initial length measured between the center of each hole in the clevis endsSuzuki provides dimensions for the following models: DT25 and DT30-3.05 in(77.5mm) DT90, DT100 and V4-4.9 in(124mrn) DT175,1988-97 DT150 and 1988-93 DT200-5.4 in(137.5mm) 1998-03 DT150-6.6 in(168.5mm) 1984-97 DT200-6.3 in(113.5mm) 1998-00 DT200-6.5 in(166.0mm) 4Install the control rod onto the anchor pins on the oil pump lever and the throttle bodv lever5Move the throttle to the fully closed position0Control rod