Suzuki outboard motors 1988 2003 repair manual., Page 85Get this manual
FUEL SYSTEM 4-23 install the carburetors followRemoval procedures may vary slightly due to differences in linkageAs explained in the description of the carburetors, the float arrangement and adjustments differ due to change in carburetor vendorThese differences are noted whenever they make substantial change in procedure12Identify each carburetor by inscribing or painting 1, and (if applicable) on the float bowl cover to ensure each carburetor will be installed back into the same position from which it was removed13Remove the mounting nuts, then remove the carburetors as an assemblyEach carburetor has separate gasket which may either come away with the carburetor, or remain on the intake manifoldRemove and discard these gasketsPlace the carburetor assembly on the workbench and remove each piece of linkage one at timeArrange the linkage on the workbench as it was installed on the carburetors, as an assist during assemblingTo install: Install each marked carburetor (in the same location as disassembly) and gasket assembly on the engine and install the correct linkages14Install the throttle sensor on the throttle shaft15Install the fuel supply hoses to the carburetors and install the plastic hose retainers16Innstall the throttle control lever and arm17Connect the oil hoses18Install the silencer cover and bolts19Connect the throttle lever rod from the carburetors20Connect the oil level switch lead wires and install the oil tank21Install the fuel inlet hose from the fuel filter22Install the engine cover23Connect the battery negative cableREMOVALINSTALLATION