Suzuki 90-200HP outboard motors Service Manual, Page 29Get this manual
Suzuki DT1S0, DT1S0SS, DT17SDT200 ;;Jffixed to coverRotate sensor driven (1) to align holes in the drive gear
OUTBOARD MOTOR
screws securely nd reconnect oil pump control rodCD! MODULE Test CD! mud ule outpu using Stevens Model CD77 or suitable equivalent peak reading voltmeterFoUoinstructions induded with tester
1b atljust throttle valve sensor, remove oil pump co mrol rod from pump lever amI disconnect hrottle valve sensor wiresCo nn ect the red test lead of ohmmeter to th light greenired wire and black est lead to th black se nso wireWith throttle valves fully closedlance should be 200-250 on mudels prior tu 1989 and 225275 on mode ls afte 1988, If not, fin,t make urethrottle valves are fully closedthen loosen sensor mo unting screws nd ro tate sensor as necessary to obtain 2:30 ohms on mod ls prior to 1989 and 250 ohms on mod els afte 1988_ Retighten
a nd th $ensor, th en insert alignment pin in ho le (2)Install sens'J assembly 011 carbureto shaft and lightly tighten mounting in th center of adjusting 510t.0;;With ca rburetor throttle valves fully dosedin stall dnngear (5), align' ing tin timing murks on drive and driven gear (FigMake ure throttle val ves are fully closed, the install and tighte thrott le shaft nllt (4-FigSZ20-lU)tighten sensor mounting ::.erews, remuve lignme nt pin and affix