Suzuki 90-200HP outboard motors Service Manual, Page 2Get this manual
SERVICE MANUAL ity SAE flO hypoid gear lubricalllGearcase capacity is mL (l8.fl flozThe gearca;e oil should be changed after the first to hours of operation and every toO hours thereaftertween int,lke manifold and cranke-aseRefer to FigSZI85The reed pe tals should seat very lightly against the reed plate throughout their entire length with the le,L;t possihle tensionRen ew reeds if tip of reed peta stands open more than 0.2 mm (O.OOS in from contact surfaceReed stop opening should be 10.5 mm (0.413 in as shown in FigSZIS-7[{ene reeds if petals are broken, eracked, warped, rllsted or bentNever attempt to bend reed petal or straighte damaged reedNever install bent or damaged reedSeating s1ll1-ac:e of reed plate should be mooth and flatWhen installing reeds or reed stop, make sure that petals are centered over the inlet ports in reed plate, anti that reed stops are centered over reed petalsApply Suzuki Thread Lock 1:342 ora suitable equivalent thread locki ng compound to threads of reed stop screws during reassemblyInstall reed vain! assemblies i.o intake manifold with alTow embossed on inside of reed plate (on one end) facing toward outside of engineSPEED CONTROL LINKAGE'11 synchronize carburetor throttle valvesloosen two screws (S-FjgSZI8-8) on top earburetor throttle lever (L)Rotate lever (L) clockwise until throttle vllves are eompletely closedthen retighten screws (S)Be sure throttle valves open and dose at exactly the same timeWith remote control in the neutral position, loosen jam nuts (N-FigSZIS-9) and adjust lengt.h of rod (I) so c:icarance of