Suzuki 8-25HP outboard motors Service Manual, Page 30Get this manual
Suzuki DT20 (1986-1988)DT25 (1985-1988) spring (11), rope guide (12), rubber plate (13) and install rope handle (16)With rope starter (14) inserted in slot of pulley (4), rotate pulley turns counterclockwise when viewed from the flywheel sideSecure pulley, then release starter rope (14) from slot in pulley and allow starter rope to slowly wind onto pulleyDo not place any more tension on rewind spring (2) than is necessary to draw rope handle up against housingRemount manual starter assembly and reassemble neutral start cable and associated componentsWith the gear shift lever in the "Forward" or "Reverse" position, mark (MFigSZ9-17) in lever (L) must be between marks (X and Y) on starter housing (1)Adjust the length of the neutral start cable to obtain the correct adjustment
OUTBOARD MOTOR
ELECTRIC STARTER
Some models are equipped with electric starter shown in FigSZ9-18Disassembly is evident after inspection of unit and reference to exploded viewStandard commutator outside diameter is 30 mm (1.18 in and should be renewed if worn to diameter of 29 mm