Suzuki 30-40HP outboard motors Service Manual, Page 20Get this manual
Suzuki DT40 (Prior to 1984) sectionDetermine type of ignition system used, as noted in IG:-.IITIO:-.l section, then refer to FigSZ12-3 and adjust the length of link (S)carburetor link (C) and lower link (L) using 'alues listed in the following tableMeasure link rod lengths between adon lower link (L)justing nuts as Independent Ignition Stawr rod (S) C"rbureto l' rod (C) Lower r"d (LI Simultaneous Ignition Sta tor rod (S) Carburetor rod (C) Lowe rod (LI Rod Length 30 mm 155.5mm 91 mm Rod Length
OUTBOARD MOTOR
straighten damaged reedNever install -a bent or damaged reedSeating surface of reed plate should be smooth and flatWhen installing reeds or reed stop, make sure that petals are centered over the inl et holes in reed plate, and that the reed stops are centered over reed petalsFUEL PUMPA diaphragm type fuel pump is mounted on the side of power head cylinder block and is actuated by pressure and vacuum pulsations from the engine crankcasesRefer to FigSZ 12-5 for exploded view of fuel pump assemblv-Wh serv Ic In pump, sc ribe reference marks across pump body to aid in reassemblyDefective or questionable parts should be renewedDiaphragm should be renewed if air leaks or cracks are found or if deterioration is evidentFigSZI25- E.plod.d 01 diaphragm type 'ue' pump assembly1Cuvt"r