Suzuki 2003-2007 DF60 DF70 Outboard Motors Service Manual, Page 198Get this manual
MID UNIT
5Install the washer and the snap pin 7, then tighten the cable lock nut against the connector to maintain adjustment6Make sure that both forward and reverse gears can be engaged with the same angle of the shift lever travel from the "NEUTRAL" positionThrottle cable to throttle control arm adjustment 1Set the throttle grip to the fully closed position2Make sure that the throttle lever is fully closed(The CTP switch must be in "ON", pushed-in, position 3Push the cable connector and the throttle cable in the direction shown by the arrow to remove all play in the cable4While pressing against the cable and the connector, adjust the connector to align with the pivot pin on the throttle control arm D5When aligned, press the connector (flat side of the connector toward the throttle control arm) over the pivot pin C6Install the washer and the snap pin F, then tighten the cable lock nut against the connector to maintain adjustment