2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 289Get this manual
Power Trim and Tilt: Installation Installation is reverse of removal with special attention to following steps Ensure that the drive joint (1) is aligned and firmly inserted into the gear pump assembly Fit O-ring (2) to PTT motor 2B-23
Power Trim and Tilt Motor Disassembly and Assembly
Disassembly 1) For correct assembly, scribe an alignment mark on the field case and brush holder2) Slide cable protector tube upward3) Remove the screw securing the motor cable holder (1), then slide motor cable holder and grommets (2) out as shown in figure2 1
Z9J0112206010
I9J011220032-02
Check the level of PTT fluid contained in the PTT pump assemblyIf level is low, add recommended PTT fluid until level with mating surface of PTT motor Ensure that the faces of the PTT motor and pump unit are free of dirt or debrisWhen attaching the PTT motor to the PTT pump assembly (3), ensure that the tip of armature shaft (4) fits firmly into the drive joint (1) Tighten the four screws (a) to specified torqueTightening torque PTT motor screw (a): Nm (0.5 kgf-m, 3.6 lbf-ft)