2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 286Get this manual
2B-20 Power Trim and Tilt: PTT Pump Assembly Install four O-rings (1) to PTT body assemblyNOTE Lubricate O-rings with PTT fluid before installing Install PTT pump assembly, then tighten three screws (a) (b) to specified torqueTightening torque PTT pump assembly bolt (a): 8.0 Nm (0.8 kgf-m, 5.8 lbf-ft) PTT pump assembly bolt (b): 5.5 Nm (0.55 kgfm, 4.0 lbf-ft) PTT Motor Install the PTT motorRefer to "Power Trim and Tilt Motor Removal and Installation" (Page 2B-22)PTT Fluid Pour recommended PTT fluid into reservoir to specified levelRefer to "Checking PTT Fluid Level" (Page 2B-10)Air Bleeding Before installing the PTT unit on the outboard motor, use the following procedure to bleed air from the system1) Support the PTT unit in an upright position in vise2) Fill the reservoir with PTT fluid to the specified level, then install oil filler plug (a) (b)