2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 223Get this manual
Starting System:
Starter Motor Disassembly and Assembly
Disassembly When overhauling the starting motor, it is recommended that the component parts be cleaned thoroughlyHowever, the yoke assembly, armature coil, overrunning clutch assembly, magnetic switch assembly and rubber or plastic parts should not be washed in degreasing tank or with grease dissolving solventThese parts should be cleaned with compressed air or wiped with clean clothNOTE Before disassembling the starting motor, be sure to put match marks at three locations ("A", "B" and "C") as shown in the figure at right to avoid any possible component alignment mistakes