2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 221Get this manual
Starting System: 7) Remove the starter motor (10), then disconnect the red lead wire (11) from "S" terminal of starter magnetic switchPull-InHold-In Test NOTE Before testing, disconnect the brush lead from terminal "M" 1I-5
Connect the battery to the magnetic switch as shown in the figure Check that the plunger and pinion (over-running clutch) move outwardIf the plunger and pinion don't move, replace the magnetic switch.I9J011190057-01
Installation Installation is in the reverse order of removal with special attention to the following steps Install the starter motor and tighten starter motor mounting bolts securelyTightening torque Starter motor mounting bolt (a): 23 Nm (2.3 kgfm, 16.5 lbf-ft)I9J011190002-02
1Terminal "S" 2Terminal "M"