2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 166Get this manual
1D-55 Power Unit Mechanical: 4) Install conrod cap (with bearing) to conrod with the embossed mark on cap toward flywheel sidec) Finally tighten bolts 60 degrees turn from the point of step b) using an angular torque gaugeTightening torque Conrod cap bolt (Final step): 60 degrees (47 m, 4.7 kgf-m, 34 lbf-ft) NOTE Purchase commercially available angular torque gauge for this step of tightening bolts I9J011140253-01
1Embossed mark
2Flywheel side
5) Apply engine oil to conrod boltsTighten conrod cap bolts in three steps as followsa) Lightly seat all conrod bolts at first, then tighten bolts 12 (1.2 kgf-m, 8.7 lbf-ft) of specified torqueTightening torque Conrod cap bolt (1st step): 12 Nm (1.2 kgfm, 8.7 lbf-ft) b) Tighten bolts 17 (1.7 kgf-m, 12.3 lbf-ft) of specified torqueTightening torque Conrod cap bolt (2nd step) (a): 17 Nm (1.7 kgf-m, 12.3 lbf-ft)