2009-2010 Suzuki DF70A DF80A DF90A Outboard Service Manual, Page 105Get this manual
Engine Electrical Devices:
IAT Sensor Inspection
Z9J0111306009
CMP Sensor Removal and Installation
1) Remove the IAT sensorRefer to "IAT Sensor Removal and Installation" (Page 1C-10)2) Immerse temperature sensing part of IAT sensor in water3) Measure resistance between sensor terminals while heating water gradually4) If measured resistance does not change in the proportion indicated, replace sensorIAT sensor specification Water temperature: (32) 25 (77) 50 (122) 75 (135)F) Resistance 0.73 0.33 5.3 6.6 1.8 2.3 (k0.96 0.45
Removal 1) Disconnect the CMP sensor lead wire connector at sensor2) Remove the bolt and CMP sensor (1)
Z9J0111306010
I9J011130046-01
Installation Installation is reverse order of removal Install CMP sensor, then tighten mounting screw securely Connect sensor lead wire connector to CMP sensor
CMP Sensor Inspection