Mercury Optimax Models 135, 150, Direct Fuel Injection., Page 461Get this manual
ATTACHMENTSCONTROL LINKAGE
CAUTION
Marine sealer must be used on shanks bolts to make water-tight installationIMPORTANT: DO NOT use an impact driver when tightening transom boltsApply marine sealer to shanks of mounting bolts (not threads) and secure outboard to transom with bolts, flat washers and locknuts, as shownBe sure that installation is water-tightInstall upper bolts so that hex head end of bolts is on the inside of boat transom
Super Ride-Guide Steering Kit Installation
IMPORTANT: Both gear racks or rotary steering heads must be installed so that both steering cables will be routed together on the same side of the boat and will push-and-pull together1Install Super Ride-Guide Steering Kit in accordance with instructions included with Super Ride-Guide Kit2Make sure that both gear racks or rotary steering heads are installed so that both steering cables are routed together down starboard side of boat and will push-and-pull together