Mercury Mariner Service Manual 6, 8, 9.9 210CC Sailpower, Page 28Get this manual
CONTINUED FROM PROCEDING PAGE No Voltage Reading Defective starter solenoid
12 Volt ReadingaReconnect yellow (starter motor) cable to starter solenoid Test Point 1bConnect voltmeter between common engine ground and Test Point 7cPush start switch
No Voltage Reading Check yellow cable for poor connection or open circuit
12 Voltage ReadingIf starter motor does not turncheck that starter motor is grounded to powerhead If starter motor is grounded to powerheadcheck starter
Ignition (Key) Switch Test (Commander Remote Control)
1Disconnect remote control wiring harness and instrument panel connectorNOTE: Refer to wiring diagram at end of this section for correct identification of connector terminals2Set ohmmeter on scale forthe following tests:
Off Positioncontinuity between black (M) and black yellow (M) Run Positioncontinuity between red (8) and purple (A) Start Positioncontinuity between red (8) and yellowred (S) purple (A) and yellow red (S) red (8) and purple (A) Choke Positioncontinuity between red (8) and yellow black (C) red (8) and purple (A) yellowblack (C) and purple (A)