Mercury Mariner Outboard 225 3 Litre Service Manual 1994, Page 197Get this manual
5 Position slot on end of swivel shaft in line with hole in tilt ram endInsert punch into tilt ram hole to align cross hole in upper swivel shaftTap new cross pin in until flush
10Apply Quicksilver Liquid Neoprene (91-255112) or all electrical connections
Electrical wires passing through cowl openings mu st be protected from chafing or being cutFollow the rec ommended procedures outlined in Section of thi !; ManualFailure to protect wires as described could reo suit in electrical system failure andor injury to occu pants of boat
Testing Power Trim System With Test Gauge Kit (91-52915A3)
a Upper Swivel Shaft (Slot is in line with cross hole) Chamfered end of hole (Faces away from transom) Retaining pin lilt ram end
IMPORTANT: This test will not locate problems in thE trim systemThe test will show if the system Is correct after repairIf minimum pressures are not obtain able, the trim system requires additional repairUse Adapter Fitting (22-11 243) to connect test gauge tc trim system