Mercury Mariner 8/9.9HP 4-Stroke Factory Service Manual, Page 49Get this manual
Ignition Cover Removal and Installation 1Loosen screw and remove coverc
(CDI) Unit Removal and Installation
1Remove and install the (CDI) unit as shown
NOTE: Ignition coil was removed in picture to show proper wire routing2Refer to Section Part for Wiring Diagrams
aIgnition CoverScrew (Tighten Securely for Reassembly)Fuse Holder (Electric Start Models) Place into Retainer
Wire Holder
1Disconnect wires for removal of ignition componentsRefer to Section Part Wiring Diagrams when reconnecting wires2Assemble the wires connections into the slots in the wire holder for best fita c