Mercury Mariner 4 and 5HP 4-Stroke Outboards Service Shop Manual 1999, Page 36Get this manual
GENERAL INFORMATION
NOTE: Leave protective masking, if present, on the face of decal until final steps of decal installationThis will ensure that the vinyl decal keeps it's shape during installation2Place the decal face down on clean work surface and remove the paper backing from "adhesive side" of decal
3Using spray bottle, flood the entire "adhesive side" of the decal with the pre-mixed wetting solution
4Flood area where the decal will be positioned with wetting solution5Position pre-wetted decal on wetted surface and slide into position
6Sta rting at the center of the decal, "lightly" squeegee out the air bubbles and wetling