Mercury Mariner 4, 5 102CC Sail 1990 Outboard Service Shop Manual, Page 147Get this manual
3Secu re ti ller handle to bottom cowlusing plate (a) lock washers (b) and bolts (c) Torque bolt to 70 lbin(8 Nm) NOTE: Studs and nuts are used on some models in place of bolt (clTorque nuts to 70 lb in(8 Nm) 5Route throttle wire to carbu retor
6Rotate tiller hand le twist grip fully clockwise (id le
position) 7Place end of throttle wi re jacket (a) into retaining bracket (b) and thread throttle wire (c) thru hole in cable retai ner (d) 8With throttle arm (e) carburetor against idle speed screw, pull slack from throttle cab le and secu re cable into retai ner by tightening screw (f)