Mercury Mariner 30/40 4-Stroke Outboard Service Manual 1998, Page 44Get this manual
GENERAL INFORMATION
ACAUTION
Be sure to comply with instructions on the label for ventilation and respiratorsing spray gun, apply one half to one mil even film thicknessLet dry, flash off for five minutes and apply another even coat of one half to one mil film thickness This urethane paint will dry to the touch in matter of hours, but will remain sensitive to scratches and abrasions for few days9The type of spray gun used will determine the proper reduction ratio of the paintIMPORTANT: Do not paint sacrificial zinc trim ab or zinc anode10Cut out cardboard "pl ug" for trim tab pocket to keep paint off of mating suliace to maintain good continuity ci rcuitry between trim tab and gear housing
Decal Application
Decal Removal
1Mark decal location before removal to assure proper alignment of new decal2Carefu lly soften decal and decal adhesive with heat gun or heat blower while removing old decal3Clean decal co ntact area with 1:1 mixture of isopropyl alcohol and water4Thoroug hly dry decal contact area and check for completely cleaned suliace