Mercury Mariner 200, 225 Optimax Outboards Service Manual, 90-855348, Page 476Get this manual
Ride Guide Steering Cablel Attaching Kit Installation (92876A3) Dual CableSingle Outboard
Apply marine sealer to shanks of mounting bolts (not threads) and secure outboard to transom with bolts, flat washers and locknuts, as shownBe sure that installation is water-tightInstall upper bolts so that hex head end of bolts is on the inside of boat transom
Quicksilver Super Ride-Guide Steering (dual cables) MUST BE USED with this attaching kitFailure to adhere to this requirement could result in steering system failureRefer to "Quicksilver Accessories Guide" to determine correct length of steering cables and remote control cables
IMPORTANT: Steering cables and remote control cables MUST BE THE CORRECT LENGTH, sharp bends on too-short cables result in "kinks"; too-long cables require unnecessary bends and! or loopsBoth conditions place extra stress on the cables and will reduce the performance of the steering system
Super Ride-Guide Steering Kit Installation
IMPORTANT: Both gear racks or rotary steering heads must be installed so that both steering cables will be routed together on the same side of the boat and will push-and-pull together1Install Super Ride-Guide Steering Kit in accordance with instructions included with Super RideGuide Kit2Make sure that both gear racks or rotary steering heads are installed so that both steering cables are routed together down starboard side of boat and will push-and-pull together