Mercury Mariner 200, 225 Optimax Outboards Service Manual, 90-855348, Page 414Get this manual
OIL SEAL CARRIER ASSEMBLYCOMPONENT REASSEMBLY (19941995 MODELS) NOTE: Complete the instructions in this section only if the assembly components have been disassembled and repaired or replaced
5Fill the area between the seal lips with 2-4-C wITeflonApply 2-4-C wITeflon to the O-ring6Install the O-ring onto the oil seal carrier
1Assemble the small oil seal (with the lips of the oil seal facing away from the driver shoulder) onto the long end of the oil seal driver2Press on the oil seal driver until the driver bottoms against the carrierDo not press so hard as to damage the oil seal carrier while driving the oil seal04-
OIL SEAL CARRIER ASSEMBLYCOMPONENT REASSEMBLY (19961997 MODELS)
70611 Oil Seal Oil Seal Driver (91-817569) use long end Oil Seal Carrier Press
The oil seals in 199611997 carrier assemblies are the same diameterThe bottom (first) seal lip faces down; the top (second) seal lip faces upApply 2-4-C wITeflon Marine Lubricant to seal lips and between sealsPress seal into carrier with suitable mandrelSecond seal should be pressed in flush with carrier surface