Mercury Mariner 200, 225 Optimax Outboards Service Manual, 90-855348, Page 355Get this manual
BEARING CARRIER ASSEMBLYComponent Disassembly and Inspection NOTE: Complete the instructions in this section only if the assembly components have been found to be defective and are in need of repair or replacement
IMPORTANT: The bearing MUST BE replaced if removed from gear
4Place the universal puller plate between the thrust washer and bearing as shown and press on the plate until it bottoms
Clamp onto the reinforcing rib of the bearing carrier ONLY, or damage to the carrier may result
1Place the bearing carrier in vise, clamping on the reinforcing rib2Removethe reverse gear, thrust ring, and bearing as an assembly, using slide hammer puller