Mercury Mariner 200, 225 Optimax Outboards Service Manual, 90-855348, Page 311Get this manual
6Position slot on end of swivel shaft in line with hole in tilt ram endInsert punch into tilt ram hole to align cross hole in upper swivel shaftTap new cross pin in until flush 11Apply Quicksilver Liquid Neoprene (91-255112) on all electrical connections
Electrical wires passing through cowl openings must be protected from chafing or being cutFollow the recommended procedures outlined in Section of this ManualFailure to protect wires as described could result in electrical system failure andor injury to occupants of boat
- Upper Swivel Shaft (Slot is in line with cross hole)Chamfered end of hole (Faces away from transom)Retaining pinTilt ram end
7Connect trim motor wires to solenoidsRefer to Wiring Diagrams in this manualRoute trim wires as specified in this manual8Reinstall anode plate to bottom of trim system9Apply marine sealer to shanks of mount bolts and install transom mount bolts