Mercury Electric Outboards 222 Thruster Service Manual, Page 39Get this manual
"RC" MODEL FOOT PEDALCONTROL CABLEIWIRING HARNESS (RUBBER HANDLE) Reassembly STEP 3
Reinstall control cable and wiring harness (rubber handle) to foot pedal, as follows: aReconnect wires from wiring harness (e) to their respective terminalsRefer to wiring diagram (see "Service Manual Outline" sheet, preceding)bThread adjustment nuts (a) all the way onto control cablescInstall No.2 control cable (''C' cable with shorter inner core wire) to foot pedalPlace inner core wire over pulley and insert wire ball end into socket in foot pedaldInstall No control cable (b) to foot pedalPlace wire ball end into socket in foot pedal, then place inner core wire on rear pulley (d) and install pulley to base with pivot pin (c)NOTE: Adjust control cables after cables are installed to control housing