Mercury 35/40HP 2 Cylinder Outboards Service Manual PN 90-42794--1, Page 226Get this manual
With retaining pin installed, position slot in direction of hole in end of tilt ramInsert punch into hole in end of tilt ram Slide retaining pin back and forth until punch locates cross pin holeIMPORTANT: Cross pin (e) should not be reusedInstall new one 5Connect trim motor wires to solenoids; refer to wiring diagrams, preceding Install neoprene wrap around cables and secure with (2) sta-strapsInstall harness retainer and clampApply Quicksilver Liquid Neoprene on all electrical connections