1986+ Mercury 6/8/9.9/10/15HP 2-stroke Factory Service Manual, Page 287Get this manual
TILLER HANDLE
5Secure tiller tube in handle with retainer and boltTorque bolt to 4.0 Nm (35 lbin)6Install tiller washer (tab aligns with slot in handle), plain washer, wave washer, plain washer and flanged bushing over cableharness assembly
aRetainerBolt [Torque to 4.0 Nm (35 lbin]Tiller washerTab h
- SlotPlain washerWave washerFlanged bushing
7Slide tiller handle assembly into anchor bracket8Route stop button harness through fuel connector opening in bottom cowl9Route control cables through opening in bottom cowl10Align tabs of inner and outer flanged bushings with slots in anchor bracket11Pull on cable ends to remove slack and secure tiller handle to anchor bracket with plate and boltsTorque bolts to 7.9 Nm (70 lbin