1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 274Get this manual

1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 274

REPOSITIONING THE CONTROL HANDLE STEPS

ACAUTION
Be extremely caref ul, when Installing control handle onto control shalt, not to pinchcut or

damage trim wires With co trol in ne utralinstall con trol handle onto shaftRei nstall trim bu tton assembly back into handle and route wires as shown MAKE SURE THAT:
ITabs ("a" in Step 6) en ter notches in back side of hand le2Neutral loc kring is positi oned so that neutral loc pin ("0" tep 5) ente rs notchhPu sh dow on hub of handle and torque set screw (a) to 70 lhsin(7.9 Nm)

Back to 1985 Mercury Outboard V-300 V-3.4L Shop Service Manual