1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 232Get this manual
RIDE-GUIDE STEERING SYSTEM INSTALLATION MODELS USING HYDRASTEER SYSTEM Installing Steering Cable to Engine
lSelect correct lengthheavy-du lYsleering cable by foll owing meas uring instructi onspreceding2Install sleering mount and sleer ing wheel in acco rdance
with ins talla tion instructions hai accompa each
IMPORTANT: Before In.talling steering cable Into till lube, lubricate seal (Figure 2) and entire cable end with Multipurpose Lubricant (C 92-7560S)3Lubricat seat (Figure 2) insid of engine lill tube and cngine steering cable end wit Muh ipurpose Lubri ca ntInser sleeri ng cable end Ih ru engine lilt tu be and secure steering cable 10 tilt lube with steeri ng cable at taching nuas shown in Figure 3Torque flul 10 35 flIbs(4.8mkg)4 Ins tall rubber bumper on inside lock ing lee eth nslal locking lee .e .er teering cahle at ta hi ng nul nd secure it co tter pin(Figure 3) Spread nds co ter pi nHe ure to install colt er pin so tha it is located inbet een tac hi ng nd grease fi ingas sho n