1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 184Get this manual

1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 184

Clutch Actuator Rod REASSEMBLY SHIMMING
Back ErM!

lInsert compression springs nlO clutch actuator rod,

fo llowed by shim washer(Figure 5) 2Pla ce small amount of Quicksilver Bearing Assembl Lubricant on locating pin (Figure 5)then position pin in cross-hole in end of clutch actuator rod with nat side of pin toward shim washer(Fig ure 6)

Shim Washer Added to Back End

aLocating PinShim WasMr(s)

cCompression SpringsClutch Actuator Rod

Figure 5Clutch Actuator Rod Sub-Assembly Sequence

Figure 8
I Shim Washer Added to Front End

Back to 1985 Mercury Outboard V-300 V-3.4L Shop Service Manual