1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 153Get this manual
REASSEMBLY and INSTALLATION IInstall exhau sllubc sealand rubber grommet as shown ill Figure Apply Quicksilver 2-4-C Mult Lube on seal and
gro mme t
2Ins.all seal nto end of wat er lube and insert wa ter tube in lo exhaust lube as sho wn in Figure 10
NOTE: Wh en in-slollingexhaust
housing
inserl th waler tube th ru ru bber rommet(Fig ure 9)
3Inslall exhaust tubeas shown in Figure 4Install new gasket(Figure I) 5Install exhau st plat as sho wn in Figure 7Torque exhaust plale rctainillg bolt 10 20 Ibsfr(37 N.m)6Position upper moUl] bracket and up per moun Is as shown in Figure 12