1985 Mercury Outboard V-300 V-3.4L Shop Service Manual, Page 43Get this manual
BRUSHES Inspecting and Replacing Brushes IIf bru shes are oil soaked or if brush length is (6.4mm) or lessreplace brushesBrush replacement inst ructions are suppli ed with brush kit
BUSHINGS Checking Bushings
Check bu shings (olle located in each end cap) fo wear Re place buhsings if worn
Lubrication
ILubricat each bu shing (one located in each cap) wi lh drop of SAE lOW oilDO NOT overlubricate2Lu bricate elical threads 011 armature shaft with drop of SA lOW oi l
Reassembly
N OTE: If brush plate ll$sembly,field assemblyand terminal stud assembly have nol been removed, start reassembly at
Slep6I Install terminal stud assembly in sequence shown in Figure 3Check wil Ohmme ter to be sure that stud is insula ted from Slar ter housing2Appl loc tit RC35 on threads of field assembly retaining screws (4)Place fi eld assembl illlo starler housing nd retain wilh screws(Figures and 10) ighte screws securel usi ng hand irnl)3ct wre nc h