1984-1986 Mercury Force 9.9 and 15HP Outboards Service Manual, Page 79Get this manual
Rmbly and InstallationSwlv.1 Breck.t Asmbly and Motor L.g1ReassemblyReverse lock assembly and shallow water drive bracket to swivel bracket: Place loot and stud in clamp screw and secure stud with spring pin
4Install tilt lock assembly as followsFigure 12APlace pivot screw with wavy washer through pivot hole in tilt lock
Slngl.Unk Syst.m:
ASecure end of link with small hook to reverse lock release leverwith spring pin
BPlace nylon spacer on screw COEFPlace spring on screw with hooked end of spring over tilt lockThread and tighten pivot screwPivot tilt lock until slot is oyer hole in sw;yel bracketPlace nylon spacer between lock and bracket and secure with pivot screw
BHook other end (large hook) of link into hole in reverse lock leverCAssemble reverse lockspring, spacers, and shallow water drive bracket by driving groove pin into swivel bracketFigure 1,