Johnson Evinrude Outboard Motors 1956-1970 1.5-40hp repair manual., Page 363Get this manual
ATOP FLYWHEEL WITH SPRINGS on the shoulder and the spindle installed againRotate the pulley slightly COUNTERcLocKwIsE and then release it to be sure there is proper engagement with the spr ing and the pulley has good spring tension5- Install the three pawls onto the three pins with the end of the pawls indexed in the three cutouts of the equalizer cupConnect the three pawl springs to the equalizer cup6- Install the three retainers over the top of the pawls, and then secure them in place with the retaining screwsROPE INSTALLATION Rope Purchase Instructions The length and diameter of the starter rope required will vary depending on the size horsepower engine being servicedTherefore, check the Hand Starter Rope Specifications in the Appendix, and then purchase quality nylon piece of the proper length and diameter sizeOnly with the proper rope, will you be assured of efficient operation following installationEach end of the nylon rope should be "fused" by burning them slightly with very small flame (a match flame will do) to melt