Johnson Evinrude Outboard Motors 1956-1970 1.5-40hp repair manual., Page 336Get this manual
HAND STARTERS
arm roves the drive gear upward to engage -, vith the teeth of the Ilvvbeel rins; gearA coil spring winds and tightens as the rope unwindsThe spring then coils the rope around pulley as the rope handle is returned to the control panelService procedures for this hand starter are presented in Section 9-4Type III This type starter is mounted atop the flywheel with three mounting legs attached to the power headThe mechanism consists of starting rope and handle, rewind spring, and an arrangement of pawls and corresponding clutch dogsThe complete assembly is contained in housing secured by three legs extending to the power headWhen the starter rope is pulled, the pawls automatically engage the clutch dogs attached to the flyweel and the engine is crankedThree models of this type starter may be installed on various JohnsonEvinrude engines covered in this manualThe first model contains pawls with return springs, center cone, and set of spring-release dogs that engage with the Ilywheel ring gear when the starter rope is pulledService procedures are presented in Section 9-5The second model does not have spring pawls or center cone, but has friction-type dogsService procedures are given in Section 9-6The third model has only one nylon pawl which engages into cut-a-ways in the outer edge of the flywheelService procedures for this model are in Section 9-7