Johnson Evinrude Outboard Motors 1956-1970 1.5-40hp repair manual., Page 182Get this manual
IGNITION
revolution and again check the gap adjustmentAfter the crankshaft has been turned and the points are on the high point of the ca m, check to be sure the hold-down screw is tight against the baseThere is enough clearance to allow the eccentr ic on the base points to turnIf the hold-down screw is tightened AFTER the point adjustment has been made, it is very likely the adjustment will be changedFollow the same procedure and adjust the other set of pointsRemove the nut from the crankshaftFlywheel Installation 18- Check to be sure the flywheel magnets are free of any metal parts19- Place the key in the crankshaft keywayCheck to be sure the inside taper of the flywheel and the taper on the crankshaft are clean of dirt or oil, to prevent the flywheel from "walking" on the crankshaft while the engine is operat inz Slide the lywheel down over the crank;haft with the keyway in the flywheel aligned with the key on the crankshaft2)- Rotate the flywheel clockwise and check to be sure the flywheel does not