2008 Evinrude E-TEC 55MFE Technical Manual, Page 212Get this manual
POWERHEAD POWERHEAD INSTALLATION IMPORTANT: Perform the following procedures before returning outboard to service: Index all spark plugsRefer to Spark Plug Indexing on p65 Adjust timing pointer and check engine timingRefer to TIMING ADJUSTMENTS on p126 Use Evinrude Diagnostics software to start powerhead break-in oilingRefer to Powerhead Break-In on p87 Prime oiling systemRefer to Oiling System Oil Supply Priming on p41 Run outboard and check for water, fuel, or oil leaks Make sure engine reaches correct operating temperature and does not overheat
Tighten adjustment screws to 60 to 84 inlbs(7
12345Adjustment screws Shift detent assembly Shift lever pin Trunnion pocket inch dimension 002125