2008 Evinrude E-TEC 55MFE Technical Manual, Page 206Get this manual
POWERHEAD POWERHEAD ASSEMBLY IMPORTANT: If new screw is used, it must be installed as aboveThen, it must be removed, relubricated, and installed againLoosen forcing screw and remove the frameTest at least three corners of the rod and cap joint with pickJoint must be smooth with no stepcase mating flangeThe sealer must not come within 14 in(6.4 mm) of bearings
Typical
IMPORTANT: Gel-Seal II has shelf life of at
least one year when stored at room temperatureTest the Gel-Seal II or replace it if the age of the tube cannot be determinedUsing old Gel-Seal II could cause crankcase air leaks
Crankcase Assembly