2008 Evinrude E-TEC 55MFE Technical Manual, Page 204Get this manual
POWERHEAD POWERHEAD ASSEMBLY dowel pin hole will help in the alignment processInstall rod cap screws finger tight (NO MORE than inlbs(1 Nm) maximum)1Lower seal housing 2Upper oil seal 3Alignment marks 002261 002116
IMPORTANT: Be sure alignment dot on rod cap
matches dot on rod and that both dots face flywheel
Lubricate each crankpin and bearing assembly with outboard lubricantSlowly pull connecting rod up to crankshaft and install bearing halves
1Alignment dots