2008 Evinrude E-TEC 55MFE Technical Manual, Page 134Get this manual
ELECTRICAL AND IGNITION CONNECTOR SERVICING Release terminal latch and gently pull on wire
AMP Connectors
IMPORTANT: Always use the appropriate meter
test probes and adapters when testing components fitted with these terminalsElectrical grease is NOT used on AMP connectors
1Terminal latch (plug) 2Terminal latch (receptacle) 42329
SUPERSEAL 1.5 Disconnect
Lift latchPull connectors apart
Terminal Installation
Push terminal through seal until it locks into placeFill connector with Electrical Grease to 132 in(0.8 mm) below ledge or end of plug
Connect
Confirm the seal is in placePush connectors together until latched