2008 Evinrude E-TEC 55MFE Technical Manual, Page 131Get this manual
ELECTRICAL AND IGNITION ELECTRIC STARTER SERVICING If the pinion does not properly engage the flywheel, the pinion and screw shaft assembly could be worn, distorted, or dirtyLocate the cause of binding and correct it before completing the assemblyInspect and replace end cap thrust washer if distorted or worn excessivelyCompress the brushes and springs with modified putty knife
Starter Assembly
IMPORTANT: If removed, apply Locquic Primer and Screw LockTM to the brush card screws before installingPlace armature in frameApply Moly Lube to the armature bushingRoute the brush leads and install the springs and brushes002309