2008 Evinrude E-TEC 55MFE Technical Manual, Page 109Get this manual
ELECTRICAL AND IGNITION ELECTRICAL HARNESS CONNECTIONS
ELECTRICAL HARNESS CONNECTIONS
Inspect wiring and electrical connectionsDisassemble and clean all corroded connectionsReplace damaged wiring, connectors, or terminalsRepair any shorted electrical circuitsRefer to wiring diagrams and reference charts to identify specific wiring detailsRefer to CONNECTOR SERVICING on p132 for connector servicing procedures
EMM J1-A Connector
Engine Harness to Stator Connector
Pin Description of Circuit No1 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 vacant Diagnostic connector Diagnostic connector vacant vacant Crankshaft position sensor (CPS) Ground, CPS (digital) Bootstrap connector (programming) Stop circuit Throttle position sensor (TPS) vacant vacant CANbus, NET-L CANbus, NET-H 12 to EMM (fused) Tachometer CHECK ENGINE signal, SystemCheck TPS Engine temperature sensor Air temperature sensor CANbus, NET-S CANbus, NET-C vacant LOW OIL signal, SystemCheck WATER TEMP signal, SystemCheck TPS ground (analog) Engine tempsensor ground (analog) Switched B+ to EMM LOW OIL switch vacant vacant Neutral switch (shift linkage) vacant vacant