2008 Evinrude E-TEC 55MFE Technical Manual, Page 88Get this manual
ENGINE MANAGEMENT MODULE (EMM) DIAGNOSTIC SOFTWARE FUNCTIONS
Oil Control Settings
Powerhead Break-In
Use the diagnostics software to start break-in oiling after powerhead rebuildThe break-in oiling program runs for two hours of outboard operation, above 2000 RPM
TPS Calibration
TPS Calibration synchronizes throttle plate opening with throttle position sensor voltageCalibrate after replacing or adjusting throttle body or throttle linkage partsRefer to TPS Calibration on p127
Idle Speed Control
Use the Idle Adjust function to increase or decrease IN GEAR IDLE speedThis adjustment offsets the basic EMM programming and will not set an absolute fixed speedAfter the offset is changed, the EMM continues to control engine operation normallyEngine idle speed is not fixed
1Break-in oil setting
TillerRemote Programming
This feature controls the start in gear protection function of the neutral switchTiller operated models, including remote models with an installed tiller conversion kit, MUST be set to TILLER