2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 305Get this manual
SAFETY If electrical parts are replaced or even removed from the outboard, check the following:
Wire and high voltage lead routing As shown in service manual Away from moving parts which could cut wires or wire insulation Away from engine cover latches which can catch and cut insulation from high voltage spark plug leads Sleeves, boots, shields In position (to avoid shock hazard) Not torn or cracked Metal Clamps Tie Straps Position as shown in manual Screws, Nuts, Washers Tighten firmlythese keep
clamps in position and ends of wires from sparking Where lock washers are called for, use them