2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 273Get this manual
GEARCASE BEARING AND SEAL REMOVAL
Driveshaft Bearing Housing
The driveshaft bearing is not serviceableReplace the bearing housing assembly if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged
Propeller Shaft Bearing Housing
Rear Seal Removal
Remove seals using Puller Bridge, PN 432127, and Small Puller Jaws, PN 432131Position the plate on top of the housing to support the bridge, and tighten jaws securely behind the inner seal
Seal Removal
Remove the driveshaft bearing housing seals using Puller Bridge, PN 432127, and Large Puller Jaws, PN 432129Discard the seals