2007 Evinrude E-Tec 75, 90 HP outboards Service Manual, Page 216Get this manual
POWERHEAD ASSEMBLY
ASSEMBLY
IMPORTANT: Proceed slowlyMake no forced
assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with outboard lubricant
If the installer sticks on the sleeve after installation, thread Slide Hammer, PN 391008, into installer and pull it off
IMPORTANT: Inspect sleeve after installationSleeve must not be used if surface is damagedUsing retaining ring pliers, install bearing retaining ring with sharp edge facing away from bearingLubricate new driveshaft O-ring and lightly lubricate crankshaft splines with Moly LubeTMInstall O-ring in sleeve
IMPORTANT: Use new wrist pin retaining rings,
gaskets, seals, and O-rings during assembly
Crankshaft